Power Rating

Minimum Rating
352 bhp
Maximum Rating
1172 bhp

Engine Specifications

Aspiration
Turbocharged-aftercooled aspiration
Configuration
Vee 12, 4-stroke-cycle diesel
Bore
5.71 in
Stroke
6.38 in
Displacement
1959 cu in
Rotation
Counterclockwise from flywheel end
Emissions
IMO III emissions certified (SCR required)
Rated Engine Speed
1500 rpm
Governor
Electronic (A5 ECM)
Refill Capacity
Lube Oil System w/ oil filter change: 146 L (38.5 gal) - deep pan
Oil Change Interval
750 hrs - deep pan
Cooling
Heat exchanger or keel cooled
Flywheel Housing
SAE No. 0 with SAE No. 18 flywheel (136 teeth)

Dimensions & Weights

Minimum Length
83.9 in
Maximum Length
89.8 in
Minimum Width
57.1 in
Maximum Width
57.3 in
Minimum Height
59.3 in
Maximum Height
63.5 in
Minimum Engine Dry Weight
6950 lb
Maximum Engine Dry Weight
7160 lb

Clean Emissions Module (CEM) – Dimensions

6 Brick Z-Flow - Length
147.7 in
6 Brick Z-Flow - Height
23.5 in
6 Brick Z-Flow - Width
43.5 in
6 Brick Z-Flow - Weight
1246 lb
6 Brick U-Flow - Length
85.0 in
6 Brick U-Flow - Height
23.5 in
6 Brick U-Flow - Width
56.9 in
6 Brick U-Flow - Weight
1235 lb
Dosing Cabinet - Length
37.4 in
Dosing Cabinet - Height
22.8 in
Dosing Cabinet - Width
18.8 in
Dosing Cabinet - Weight
209 lb
  • AIR INLET SYSTEM
    • Separate circuit aftercooled (SCAC)
    • Closed crankcase fumes disposal
  • CONTROL SYSTEM
    • 24V control system
  • COOLING SYSTEM
    • Heat exchanger or Keel Cooling
    • Watercooled exhaust manifold and turbocharger
    • Hard seawater lines – no flexible hoses
    • Flanges for cooling connections, ANSI or DIN
  • FUEL SYSTEM
    • Duplex fuel filters with hybrid fuel lines
    • Shipped loose primary fuel filter with water separator
    • Fuel transfer and priming pump
  • LUBE SYSTEM
    • Oil fill, simplex filter and dipstick
    • Deep or shallow sump oil pan
  • MOUNTING SYSTEM
    • Adjustable front support mounting system
  • GENERAL
    • Right or left hand service sides
    • Customer wiring and service tool connector
  • ALARM AND PROTECTION
    • MECP I control panel
    • MECP III control panel with Cat® Alarm and Protection System
  • EXHAUST SYSTEM
    • Water-in-fuel and exhaust temperature sensors
    • Muffler
  • CHARGING SYSTEM
    • Charging alternator
  • FUEL SYSTEM
    • Manual or electric fuel priming pump
    • Fuel cooler
  • LUBE SYSTEM
    • Duplex oil filters
  • POWER TAKE-OFFS
    • Front drives including stub shaft and pump drive
    • Rear SAE A or B pump drives
  • STARTING SYSTEM
    • Starting motors – air, electric or redundant
Get in touch Your Nearest Location
[contact-form-7 404 "Not Found"]
Two dads havin' fun.
Splishin' & splashin' in the hot summer sun.